This document could not be shown here. Open the PDF.
Text of this document3 pages · 349 words
Page 1
LoxoneQuick Configuration Guide Issue 1 The top DIN rail is usually reserved for LoxoneInner lid termination and therefore blanked off with 1 x LXN-BP (Blanking Plate) Always align your Loxone modules with the left hand edge of the inner lid slot and work left to right, this ensures you can use our 30 MOD range of LXN-MTP’s (Module Trim Plates) Example Module Trim Plate to cover any unpopulated exposed areas. See LXN-MTP tech sheet for range Unused spaced can also be filled by using DIN Rail Blanks (LCP-DRB) Power supplies are usually mounted on the left Circuit Breakers & Isolator switch usually mounted on the RHS Issue 1 1
Page 2
LoxoneQuick Configuration Guide Roughly layout your Loxonemodules, using best practice rules of keeping low voltage separated from high voltage and audio away from mains etc. (where possible). Always start from the left, sum up the width of the modules, you can fit a total of 544mm (30 Mod) once you reach that you will need to start on a new rail. 157mm 157mm 35.4mm 35.4mm 157 157 35.4 35.4 --------- =383 --------- 544-383 = 161mm 383mm remaining usable space Sum up the width of the Loxonemodules on the following rails. You will then need to fill the unused space on a rail either by using (LCP-DRB DIN Rail Blanks or by selecting one of our LXN-MTP Module Trim Plates, see MTP Tech sheet. If using MTP’s once you have everything wired and in its final position for extra neatness you can use some 6mm double sided tape (3M™ Double Coated Paper Tape 9086) to stick the trim plates to the lid. A spreadsheet is a great tool for calculating Module space on the din rails. Issue 1 2
Page 3
LoxoneQuick Configuration Guide For the LXN#-D (Deeper Pan range) you can split each DIN rail 60/40 or 40/60 25mm Use “LXN-D-440- 216mm TXBP” dedicated trim plate 353mm 40% Mounted off the brackets for deeper power supplies 40% Mounted off the brackets for deeper power supplies Can also have 100% of the DIN rail mounted on or off the brackets Issue 1 3
Need assistance or looking to source this item?