Lutron Energi Savr Node – PRO LED+ Phase Adaptive Power Module – QSNE-4A5-230-D
The QSNE-4A5-230-D is a four-zone phase adaptive dimming module for use in an Energi Savr Node system, or in a Lutron Quantum, Athena or myRoom system. Each zone dims LED, halogen and other mains loads, and can be set to leading or trailing edge. A standalone system is programmed through the QSE-CI-AP-D interface.
Legacy product familyThis is a legacy product family. We still have some stock of this family, please contact us to discuss your requirements.Contact us to discuss your requirements
- Refurbished In-House
Components repaired or replaced where needed, then cleaned and bench tested.New, Box Opened
Unused surplus stock with opened packaging. This unit is sold untested. - Specification Help
Need help with specification or compatibility? Speak to our team.
Specification
Additional information
| Manufacturer | Lutron |
|---|---|
| Range | Energi Savr Node |
| Model | QSNE-4A5-230-D |
| Product Type | Mains Dimming Modules |
| Number of zones | 4 |
| Power | 220–240 V~ 50/60 Hz, 10 A maximum total input current. Standby power 3.5 W typical |
| Dimming type | Leading and trailing edge |
| Load ratings | Zone 1: LED 1.7 A (400 W); incandescent / halogen and ELV 1200 W; neon / cold cathode and MLV 800 VA (525 W). Zones 2–4, each: LED 1.0 A (250 W); incandescent / halogen and ELV 800 W; neon / cold cathode and MLV 500 VA (375 W). 10 A maximum per module |
| Minimum load | None |
| Load control | Auto-detect mode starts in reverse phase (trailing edge) and converts to forward phase (leading edge) if an incompatible load is detected. One load type per zone. Internal relay gives an air-gap off when all zones are off. For dimmable loads only |
| QS link | Neither supplies nor consumes power draw units (PDUs) |
| Programming | QS standalone: Energi Savr app on an iOS device through a QSE-CI-AP-D programming interface; no programming from the module's buttons. Athena Designer, Quantum Designer or myRoom Designer |
| Width | 12 DIN modules (216 mm) |
| Dimensions | 216 × 90 mm, 76 mm deep |
| Mounting | Lutron DIN panel, or an IP20 (minimum) enclosure with integrated DIN rail. Room ambient 0–40 °C; 0–60 °C inside the panel within 20 mm of the module. 75 BTU/hr maximum |
| Environment | Relative humidity less than 90%, non-condensing. Indoor use only |
| Regulatory approvals | IEC/EN 60669-2-5, CE marked, RoHS compliant |
Specification Sheets & Documents
- Energi Savr Node PRO LED+ Phase Adaptive Power Module QSNE-4A5-230-D – specification submittal (3691158d)View PDF: Energi Savr Node PRO LED+ Phase Adaptive Power Module QSNE-4A5-230-D – specification submittal (3691158d)
Not sure it’s the right part?
Speak to our in-house specialists about your system, we’ll help identify the part you need.
