Rako WCM-D Technical Specifications

Page 1

Datasheet WCM-D Rako Wired Switch Interface What is the WCM-D? Technical Data The WCM-D allows custom and third-party switch plates to Dimensions 64x40x15mm be used in place of a Rako wired keypad (WCM/WK-EOS/WK- MOD etc.) Fixing Standard UK single gang back box, minimum 35mm depth, advised 47mm depth The WCM-D will fit inside a single gang UK back box. Up to eight switch inputs can be used per WCM-D. The switch Weight 29g plate can be formed of latching or momentary action switches connected by short wires to terminals on the WCM-D. Input Supply 12-18V DC supply from Rako Wired network NB Cable Type UTP CAT5e or CAT6 Excessive cable lengths can pick up noise, which can cause Terminals 8 Way screw-down connector for CAN intermittent operation or spurious triggering, the bus. 10-way screw-down connector for 8 recommended maximum cable length is 300mm. dry contacts, common and setup Climate Range Temperature +2C to +40C Features Humidity +5% to 90% non-condensing • Scene selection Standards RoHS • Scene toggle UKCA, CE EN 60669-2-5:2016 • Level toggle Communication CAN bus • Fade toggle (push dim) • Room/Channel raise and lower Installation and Setup • Whole House controls • Momentary or Latching switches For information on installing and setting up the WCM-D, see the WCM-D Manual. Connections/Dimensions Document Version 2.0.0 telephone +44 (0) 1634 226666 | www.rakocontrols.com WE RESERVE THE RIGHT TO CHANGE THE SPECIFICATION AND DATA HEREWITH WITHOUT NOTICE. © 2024 RAKO CONTROLS LIMITED