This document could not be shown here. Open the PDF.
Text of this document4 pages · 392 words
Page 1
Instruction Manual RxLINK Wireless RAK Receiver 2024 Version 2.0.2
Page 2
For programming information: Wireless RAK Programming guide or Wired system Programming Guide For general system information: Wireless RAK Application Sheet. Contents 1WhatistheRxLINK? 2Installing the RxLINK 3ProgrammingtheRxLINK 4Initial checks Appendix 1: LED Diagnostics 1WhatistheRxLINK? TheRxLINKisaRakoWirelessreceiver for the RAK8, the unit is poweredfromtheRAK8anddoesnotrequireanyadditional connections. TheRxLINKmustbeconfiguredinRasoftProtofunction. A maximumof16circuits can be mapped to the RxLINK, if additional circuits are required then more RxLINKs may be added. 2Installing the RxLINK Installation should only be carried out by a competent electrician. Modulesshouldbemountedinareasthatareadequatelyventilated, dry, and outside of any enclosed metal casings that may interfere with the Rako Wireless signal. Modulesshouldbemountedvertically, with the terminals at the bottom, or horizontally. Whilethemodulesaredesignedtobemaintenance-free, they should be mounted in an accessible location should investigation or re-addressing of the units be necessary. RxLINK Manual Version 2.0.2
Page 3
Step 1 Fix the mounting bracket close to the RAK8, and ensure that there is enough length on the RJ45 cable to the RJ45 port. Step 2 Connect the RJ45 cable into the RAK8intoPort 1. If looping in and out of more than one RAK8, use the second port. NB Ensure that the cable is fed through the knockouts on the top, bottom or side. 3ProgrammingtheRxLINK For instructions on programming the RxLINK using a Rasoft Pro and a Programming Tool, see Section 3 of the Wireless RAK Programming guide. 4Initial checks Theinternal LED behind the clear button will flicker when the module receives a Rako Wireless message, which is a useful diagnostic indicator. The LED feedback becomes inactive after 20 minutes to avoid a nuisance light spill. It can be re-activated by pressing the clear button. Ensurethat the RAK connected to the RxLINK has supply power, without this the RxLINK will not function. Ensurethat the RxLINK is connected to port 1 of the RAK. RxLINK Manual Version 2.0.2
Page 4
Appendix 1: LED Diagnostics Wireless Range LEDPulses Description GoodRakoWirelessreception Whentheunitisreceiving successfully, there will be four rapid pulses on the LED when any Rako Wireless message is sent. BadRakoWireless reception Whentheunitisoutofrange, there will be intermittent pulses on the LED when any Rako Wireless message is sent. NB It is recommended to install a Rako Wireless repeater (WRB-100) if you are experiencing intermittent wireless range. Should the module not respond to any of the above, press the button on the RxLINK and check the supply Voltage of the connected RAK. RxLINK Manual Version 2.0.2
Need assistance or looking to source this item?