Rako RMS-800 Instruction Manual

Page 1

Instruction Manual RMS-800 800VA Wireless Switching Unit

2025 Version 2.0.1

Page 2

Contents

1.0 What is the RMS-800? 2 2.0 Loadings 3 3.0 Installation 3 4.0 Initial Checks 4 5.0 Programming the RMS-800 4 6.0 Appendix 1: LED Diagnostics 5

RMS-800 Instruction Manual | Page 2 Manual Version 2.0.1

Page 3

1.0 What is the RMS-800?

The RMS-800 is a wireless switching module suitable for use with non-dimmable loads such as:

Non-dimmable lighting Fans Pumps Contactors

RMS-800 modules can be controlled by any Rako device that transmits Rako Wireless messages.

2.0 Loadings

Minimum Maximum 1VA 800VA

NB Inrush currents must be taken into account when calculating the load for the RMS-800

3.0 Installation

Installation should only be carried out by a competent electrician.

RMS-800 modules should be mounted in adequately dry and ventilated areas outside of any enclosed metal casings that may interfere with the wireless signal.

Modules should be mounted vertically, with the terminals at the bottom, or horizontally.

While the modules are designed to be maintenance-free, they should be mounted in an accessible location should investigation or re-addressing of the units be necessary.

Ensure that the cable clamp is fitted tightly to secure the cables.

RMS-800 Instruction Manual | Page 3 Manual Version 2.0.1

Page 4

Remove the cover 1 and cable clamp

Insert the supply 2 IN cables as well as the load OUT cables.

Replace the cable 3 clamp, ensuring the cables fit securely

Replace the cover 4

4.0 Initial Checks

When power is initially connected to the module, the load should power up to full brightness.

The clear button can be used as a manual on/off switch to test the circuit.

The internal LED behind the clear button will flicker when the module receives any Rako Wireless message and is a useful diagnostic indicator. This function becomes inactive after 20 minutes to avoid a nuisance light spill but can be reactivated by pressing the clear button. For more information on LED diagnostics, see 6.0 Appendix 1: LED Diagnostics.

Should the module not respond to any of the above, further investigation must be made before proceeding further.

RMS-800 Instruction Manual | Page 4 Manual Version 2.0.1

Page 5

5.0 Programming the RMS-800

Once the RMS-800 has powered up and has been tested with the setup button, the device is ready to be programmed.

Programming using a RAMPI or HUB using Rasoft Pro Wireless System Setup Guide

Programming using an RCM Keypad Programming With An RCM Guide.

For further general information relating to the RMS-800, see the Wireless Module Application Sheet.

RMS-800 Instruction Manual | Page 5 Manual Version 2.0.1

Page 6

6.0 Appendix 1: LED Diagnostics

Wireless Range LED Pulses Description Good wireless reception When the unit is receiving successfully, there will be four rapid pulses on the

LED when any wireless message is sent. Bad wireless reception When the unit is out of range, there will be intermittent pulses on the

LED when any wireless message is sent.

NB It is recommended to install a wireless repeater (WRB-100) if you are experiencing intermittent wireless range.

Should the module not respond to any of the above, check the supply voltage.

For additional diagnostic information, see the Wireless Device LED Diagnostics

RMS-800 Instruction Manual | Page 6 Manual Version 2.0.1