Rako EOS Plate Care Guide

Page 1

application sheet RAKO CONTROLS EOS PLATE CARE INSTRUCTIONS Plate Finishes Installation EOS plate finishes are available in Do not install on wet plaster or paint (masking/painter's tape adhesive can 7 standard finishes; damage the finish of a plate). All plates should be fitted by a competent Matt White (WH) person and earth connection on the grid assembly be made where necessary. Matt Black (MB) Take care not to overtighten the screws when fixing the grid assembly as this may distort the grid and prevent the plate from fitting correctly. Satin Chrome (SC) Polished Chrome (PC) Matt Bronze (BM) The keypad is orientated with the LED light Antique Brass (AB) holes at the top outer corner of each button. Polished Brass (PB) Plates are hand finished resulting in each plate being unique. Differences in colour of plate finishes shown in photos across Rako’s website are due to lighting The front plate is connected by four clips in at the time of photography. the corners of the plate Where engraving exposes natural brass the colour will organically age over time. Cleaning Information No abrasive or solvent-based Press the front plate to the grid with the treatment should be used. Plates, matching indents for the four clips should only be cleaned with a soft, non abrasive dry cloth. Removal of the plate is achieved by inserting a small flathead screwdriver between the indent at the bottom of the plate and the grid. telephone +44 (0) 1634 226666 www.rakocontrols.com