Lutron RadioRA 3 System Architecture – architecture for 230 VAC and 868 MHz regions (P/N 368-6138/EA Rev A, 01/2025)

Page 1

Architecture for 230 VAC and 868 MHz regions RadioRA 3 System Capacities RadioRA 3 Processor • Up to four processors per system to increase flexibility and extend range • 1 RJ-45 Ethernet port for programming/integration Network Link • In-line controls, window treatments, Pico wireless controls, and sensors • Two-way wireless communication (Clear Connect – Type A) • Powered by an IEEE 802.3af-2003 or 802.3at-2009 1 2 compliant Power over Ethernet (PoE), supply, Lutron - Maximum of 200 devices or 200 zones per RadioRA 3 system (includes 4 auxiliary/wireless repeaters and 1 processor address) model L-POEI-G-BL or by others Internet - RF range between repeaters is 18 m and 9 m to other devices, with a total • Standard Ethernet wiring (100 m max) used to possible coverage area of 762 m2 per repeater/processor connect processors to network Lutron app • Vierti keypads, hybrid keypads, and Lumaris (Clear Connect – Type X) • 10/100 Mbit Ethernet 1 - Maximum of 200 devices per RadioRA 3 system Home - Each Vierti device should be within 23 m of the processor network router - E ach Clear Connect – Type X device should be within 6 m of at least two Key – Power other Clear Connect – Type X devices - At least two Clear Connect – Type X devices must be within 6 m from Third-party integration 1 Line voltage 230 VAC Lutron Designer software the processor 2 Low voltage 24 VAC 3 Low voltage 24 VDC Key – Wiring 4 Low voltage 12 VDC 5 Plug-in transformer Network link (Ethernet) 6 Battery powered 7 RadioRA 3 processor 3 7 RadioRA 3 processor Low-voltage (2 conductor) Power over Ethernet (PoE) Clear Connect – Type X Clear Connect – Type A 1 1 6 6 1 Vierti keypad Vierti hybrid Pico wireless Radio Powr Savr wireless Lamp dimmer 1 1 keypad control occupancy/vacancy sensors 3 QSPS 10-output Flush-mounted and J-box- Sivoia QS wireless power panel mounted power supplies and Palladiom blinds 3 3 1 1 1 5 In-line dimmer In-line switch Fan speed control Wireless repeater 1 1 Lutron LED Lumaris RGB + tunable RadioRA3 multi-channel tape extrusion white tape light wireless controller 1 4 6 Plug-in power supply 12 V panel Triathlon blinds or Lutron CE power interface 1 1 2 or 3 RF Softswitch RF 0-10V RF contact closure module module output module 6 Palladiom Wire-Free blinds Note: Not all available products are shown. 1 Device – Any system component that requires a single address. Four addresses are reserved only for auxiliary/wireless repeaters on the Type A link (1 processor, 4 repeaters, and 95 additional devices). 2 Zone – An output. An individual shade, dimmer, switch, or contact closure output. 3 The wire gauge required for shades power conductors is dependent on shade size and number, wire run length, and power supply type being used. The wire gauge required for the tape light power conductors is dependent on the wire run length and power supply being used. Consult technical specifications of shade equipment for details. © 01/2025 Lutron Electronics Co., Inc. P/N 368-6138/EA REV A